Spark Controllers, EDM Logic Controller, Micro Controller Based EDM Logic Controllers, Machine Tools, Horizontal Sparking Attachment

PRODUCTS

Products : SZNC-20-3520

Spark controller

Embedded EDM Logic ZNC Controller

Provides :

• High Reliability.
• Very Low Break Down Rate.
• High Performance In Machining.
• Good Surface Finish On Actual Job.
• Low Power Consumption.
• Edm Drilling At The Rate 2 Mm / Min.

Machine tool

• Compact & Rigid Design.
• Machine Base With Honeycomb Structure.
• Ball Screws For All Three Axis.
• Linier Motion Guide For Table Movement
• Operator Friendly Drain System.

Std. Accessories

• Digital Read Out System For 3-Axis.
• Axis Corrector With Third Axis Alignment.
• Vee Holder For Square & Round Shank.
• Flush Aid.
• Small Electrode Holder.
• EDM Drill Chuck.

Optional accessories

• Rotory Assembly For Electrode
• Horizontal Sparking Attachment

Specifications

MACHINE TOOL -3520

MODELS	UNIT	S 20 - 3520
Work Tank Dimensions	mm	600 x 370 x 250
Table Size	mm	350 x 200
X - Axis Travel With Ball Screw	mm	200
Y - Axis Travel With Ball Screw	mm	120
Z - Axis Travel With Ball Screw	mm	150
Table Assembly Construction	2	With LM Guides
Maximum Job Height	mm	140
Maximum Job Weight	Kgs.	100
Day Light	mm	410
No. Of Filters	No.	1
Dielectric Tank Capacity	ltrs	200

ZNC CONTROLLER - 20 Amps

CONTROLLER TYPE		Embedded EDM Logic Controller
Nominal Current	Amp.	20
Best MRR (Cu to Steel)	Mm³	140
Best Surface Finish	Ra	0.5
Minimum Electrode Wear	%	0.1
Maximum Electrode Weight	Kgs.	20
Connected Load	KVA	2
Z Axis Motor	TYPE	Dc Micro stepping motor
No Of ON Time Settings	No	99
No Of OFF Time Settings	No	99
No Of Step In One Program	No	10
Program Memory	Nos	99